7.2 DHCP client
This section describes commands of the Dynamic Host Configuration Protocol (DHCP).
7.2.1 The "show" commands
This section describes commands with which you display various settings.
7.2.1.1 show ip dhcp client stats
Description
With this command, you display the statistical counters of the DHCP client.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show ip dhcp client stats
Result
The counters are displayed.
7.2.1.2 show ip dhcp client
Description
With this command, you display the configuration settings of the DHCP client.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Network protocols
7.2 DHCP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
282 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General