The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vlan port config[{port<interface-type><interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
port Keyword for a port -
interface-type Type of interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries of all available interfaces
are displayed.
Result
The information about the ports is displayed.
6.1.1.11 show vlan private-vlan
Description
This command shows the specific information for all or for a selected private VLAN type.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vlan private-vlan [{primary|isolated|community}]
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
170 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General