8.2.1.4 show ip igmp snooping groups
Description
This command shows information about IGMP snooping for all or a selected VLAN.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode or in the Global configuration
mode.
The command prompt is as follows:
cli> or cli# or cli(config)#
Syntax
Call up the command with the following parameters:
show ip igmp snooping groups [Vlan <vlan id> [Group <Address>]]
[{static|dynamic}]
The parameters have the following meaning:
Parameter Description Range of values / note
Vlan Keyword for a VLAN connection -
vlan id Number of the addressed VLAN 1 ... 4094
Group
Address
-
● static
● dynamic
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The information about IGMP snooping is displayed.
8.2.1.5 show ip igmp snooping mrouter
Description
This command shows the ports at which IGMP queriers are connected for all or a selected
VLAN..
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 377
To Next Page
Loading...
Need help?
General