8.6 Multicast
The commands in this section configure the procedures for handling Multicast frames.
The commands allow the following:
● Configuration of groups
● IGMP
● Blocking unknown Multicast frames.
With the "show" commands, you can display the configuration data.
With the following commands, note which "Base bridge mode" you are in. If you are in the
"Transparent Bridge" mode, all settings relate to the management VLAN: VLAN 1.
You change the mode with the base bridge-mode command.
8.6.1 The "show" commands VLAN bridge)
This section describes commands with which you display various settings.
8.6.1.1 show mac-address-table
Description
This command shows the table with the static and dynamic unicast MAC addresses and
multicast MAC addresses.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table [vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>]
[interface <interface-type><interface-id>]
Layer 2 management protocols
8.6 Multicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
420 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General