Result
The settings for the spanning tree function are displayed.
Further notes
You can show further settings for special aspects of the Spanning Tree Protocol with the
following commands:
● show spanning-tree active
● show spanning-tree bridge
● show spanning-tree detail
● show spanning-tree interface
● show spanning-tree root
● show spanning-tree mst
6.3.1.2 show spanning-tree active
Description
This command shows the settings for the active ports of the spanning tree function.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show spanning-tree active [detail]
The parameter has the following meaning:
Parameter Description
detail Shows settings in detail
Result
The settings for the active ports of the spanning tree function are displayed.
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 219
To Next Page
Loading...
Need help?
General