The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show qos-trust-mode
Result
The list for all ports with the corresponding Trust mode is displayed.
10.5.2 Commands in the Global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
10.5.2.1 qos
Description
With this command, you change to the QOS configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
qos
Result
You are now in the QOS configuration mode.
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 483
To Next Page
Loading...
Need help?
General