Syntax
Call the command without parameter assignment:
no ip dhcp-server
Result
The DHCP server is disabled.
Further notes
You enable the DHCP server with the ip dhcp-server command.
7.3.2.3 ip dhcp-server icmp-probe
Description
With this command you enable the function "Probe address with ICMP echo before offer". The
DHCP server checks whether or not the IPv4 address has already been assigned. If no reply
is received, the DHCP server can assign the IPv4 address.
Note
With static assignments, this check is not made.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server icmp-probe
Result
The function is enabled.
Further notes
You disable the function with the no ip dhcp-server icmp-probe command.
Network protocols
7.3 DHCP server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 291
To Next Page
Loading...
Need help?
General