The parameters have the following meaning:
Parameter Description Range of values / note
idle Keyword for the time period of a xxxx con‐
nection
-
tcp Keyword for the time period of a TCP con‐
nection
-
udp Keyword for the time period of a UDP con‐
nection
-
Result
The time periods are reset.
Further notes
You delete the periods of time with the ip nat timeout command.
You display the current configuration with the command.
9.1.3 Commands in the Interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
9.1.3.1 ip nat
Description
With this command, you enable NAT for the IP interface.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 439
To Next Page
Loading...
Need help?
General