Commands relating to other topics that can be called in the VLAN Configuration mode can be
found in the relevant sections.
● If you exit the VLAN Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the end command, you return to the Privileged
EXEC mode.
8.2.3.1 ip igmp snooping static-group
Description
With this command, you create a static IGMP entry in the FDB.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
ip igmp snooping static-group <mcast_addr> ports <interface-type>
<iface_list>
The parameter has the following meaning:
Parameter Description Range of values / note
static-group Keyword for a static entry -
mcast_addr Value for a multicast address Enter a valid multicast address.
ports Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface
iface_list Module no. and port no. of the interface
Result
The static IGMP entry has been created.
Further notes
You delete a static IGMP entry with the no ip igmp snooping static-group command.
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 385
To Next Page
Loading...
Need help?
General