7.9 ARP
This section describes commands of the Address Resolution Protocol (ARP).
7.9.1 The "show" commands
This section describes commands with which you display various settings.
7.9.1.1 show ip arp
Description
With this command, you display the IP ARP table.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip arp [{vlan<vlan-id(1-4094)>|<interface-type><interface-id>|
<ip-address>|<mac-address>|summary|information}]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 ... 4094
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
ip-address Shows the IP addresses of the entries
in the ARP table
-
mac-address Shows the MAC addresses of the en‐
tries in the ARP table
-
summary Shows a summary of the entries in the
ARP table
-
information Displays information on the ARP config‐
uration
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the IP ARP table is displayed.
Network protocols
7.9 ARP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 363
To Next Page
Loading...
Need help?
General