Further notes
You also still need to enable MAC authentication for every port intended to use this function.
You do this with the dot1x mac-auth command in the Interface configuration mode.
You disable the function with the no dot1x mac-auth command.
You display this setting and other information with the show dot1x command.
11.5.2.4 no dot1x mac-auth
Description
With this command, you disable MAC authentication for the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dot1x mac-auth
Result
MAC authentication is disabled for the device.
Further notes
You enable the function with the dot1x mac-auth command.
You display this setting and other information with the show dot1x command.
11.5.3 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
528 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General