You can display the status of this function and other information with the show vlan device
info command.
8.1.2.3 gvrp
Description
With this command, you enable the GVRP function for all or individual interfaces on the device.
Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Syntax
Call the command without parameters:
gvrp
Result
In the Global configuration mode: The GVRP function is enabled on the device.
In the Interface configuration mode: The GVRP function is enabled for this interface.
Further notes
If you have enabled the GARP module, you start GVRP explicitly with this command.
If you want to disable the function for a specific interface on the device, use the no gvrp
command.
You can display the status of this function and other information with the show vlan device
info command.
8.1.2.4 no gvrp
Description
With this command, you disable the GVRP function for all or individual interfaces on the
device.
Layer 2 management protocols
8.1 GARP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 373
To Next Page
Loading...
Need help?
General