Parameter Description Range of values / note
all This parameter appears at several points in the command.
● no ports all
This command removes all Member Ports (Tagged Member
- M) from the VLAN.
● no ports untagged all
This command removes all Untagged Member Ports (U) from
the VLAN. Afterwards the ports are Tagged Members (M) in
the VLAN.
● no ports forbidden all
This command removes all Forbidden Ports (F) from the
VLAN.
-
forbidden Keyword for forbidden interfaces or ports -
name Keyword for the name assignment -
vlan-name Name of the VLAN max. 32 characters
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The ports are removed from the VLAN configuration.
Further notes
It is possible to remove individual ports from a VLAN configuration without needing to rewrite
the entire configuration.
You display details of the function with the show vlan command.
You configure the setting with the ports command.
6.1.4.5 priority
Description
With this command, you assign a priority to the VLAN. The selected priority is entered in all
incoming frames of this VLAN. The switch sorts the frame into a queue according to this
prioritization .
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 197
To Next Page
Loading...
Need help?
General