Further notes
With the show dot1d mac-address-table static unicast command, you display the
list of configured entries.
With the no mac-address-table static unicast command, you delete an entry.
8.5.4.2 no mac-address-table static unicast
Description
With this command, you delete a static unicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
The parameters have the following meaning:
Parameter Description Range of values / note
aa:aa:aa:aa:aa:aa MAC address of the interface -
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show dot1d mac-address-table static unicast command, you display the
list of configured entries.
With the mac-address-table static unicast command, you create an entry.
Layer 2 management protocols
8.5 Unicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 419
To Next Page
Loading...
Need help?
General