The parameters have the following meaning:
Parameter Description Values
session-id Number of the session 1
interface Keyword for a an interface description -
interface-
type
Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Note
Selecting the destination port
A port that is part of a port channel cannot be configured as the destination port for a monitor
session.
Result
As soon as you have configured the settings for the port to be monitored and the destination
port, the session is complete and active.
Note
If you change the settings for an existing session, all previous configurations of this session
are lost.
Further notes
You delete the destination for mirroring a port with the no monitor session ...
destination command.
You end and delete a session with the no monitor session command.
You display the configuration settings with the show monitor session command.
12.5.2.6 no monitor session destination
Description
With this command, you delete the destination for mirroring a port.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
Diagnostics
12.5 Port Mirroring
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 593
To Next Page
Loading...
Need help?
General