Parameter Description Range of values / note
restricted-tcn Shows whether spanning-tree
restricted-tcn is enabled.
-
state Shows the status of the interface. -
stats Shows the counters of the various
BPDU transmissions.
-
detail Shows detailed information about the
spanning tree settings of the interface.
-
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The settings of the ports for the spanning tree function are displayed.
6.3.1.6 show spanning-tree interface layer2-gateway-port
Description
This command shows the settings of Layer 2 Gateway Port (L2GP). For example the priority,
the MAC address and the status of L2GP are displayed.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show spanning-tree interface
[<interface-type><interface-id>]
layer2-gateway-port
The parameters have the following meaning:
Parameter Description Range of values / note
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
222 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General