Result
NAPT is deactivated for the selected IP interface.
Further notes
You enable NAPT for the selected IP interface with the ip nat napt command.
You display the current configuration with the show ip nat summary command.
9.1.3.5 ip nat pool
Description
With this command, you configure a pool for dynamic address translations.
As default, the device cannot be reached from an external network. If the device wants to
communicate in an external network, an inside global address is assigned to it dynamically.
Using this inside global address, the device can be reached from the external network until
the timer of the connection elapses.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ip nat pool <inside global ip> <mask>
The parameters have the following meaning:
Parameter Description Range of values / note
inside global ip Start address for the dynamic assign‐
ment of addresses at which devices will
be reachable from external.
Enter a valid IPv4 address.
mask Address mask of the external subnet Enter a valid subnet mask.
Result
A pool is defined.
Further notes
You delete a dynamic address translation with the no ip nat pool command.
You display the current configuration with the show ip nat command.
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
442 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General