Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
interface ([<interface-type> <interface-id>]
[<interface-type> <interface-id>]
[port-channel <1-8>]])
[forbidden-ports ([<interface-type> <interface-id>]
[<interface-type> <interface-id>]
[port-channel <1-8>]])
The parameters have the following meaning:
Parameter Description Range of values / note
aa:aa:aa:aa:aa
:aa
MAC address of the interface -
interface Keyword for a an interface description -
interface-type Type of interface Specify a valid interface.
interface-id Module no. and port no. of the interface
port-channel Specifies the name of a port channel 1-8
forbidden-
ports
Keyword for the interface description of the
blocked ports
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The entry in the forwarding database is generated.
Further notes
With the show dot1d mac-address-table static multicast command, you display
the list of configured entries.
With the no mac-address-table static multicast command, you delete an entry.
10.2.2.2 no mac-address-table static multicast
Description
With this command, you delete a static multicast MAC address entry from the forwarding
database.
Requirement
You are in the Global configuration mode.
Load control
10.2 Static MAC filtering
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
466 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General