The parameter has the following meaning:
Parameter Description Range of values / note
pvlan-type Displays information on all PVLAN
types.
-
primary Displays information on the Primary
PVLAN.
-
isolated Displays information on the Isolated
Secondary PVLANs.
-
community Displays information on the Community
Secondary PVLANs.
-
If you do not select any parameter from the parameter list, the entries of all available types are
displayed.
Result
The information for the selected private VLAN type is displayed.
Further notes
You define a private VLAN type private-vlan command.
6.1.2 Commands in the global configuration mode (VLAN bridge)
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
6.1.2.1 base bridge-mode
Description
With this command, you configure whether or not the device forwards frames with VLAN tags
transparently (IEEE 802.1D/Transparent Bridge) or takes VLAN information into account (IEEE
802.1Q/VLAN Bridge).
Note
Changing base bridge mode
Note the section "Changing base bridge mode". This section describes how a change affects
the existing configuration.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 171
To Next Page
Loading...
Need help?
General