Siemens SCALANCE XR-300WG User Manual

Syntax
Call the command without parameters:
show events sender email
Result
The configured e-mail sender address is displayed.
7.6.1.3 show events smtp-port
Description
This command shows the configured SNMP port.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show events smtp-port
Result
The configured SMTP port is displayed.
7.6.2 Commands in the Events configuration mode
This section describes commands that you can call up in the EVENTS configuration mode.
In the Global configuration mode, enter the events command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
● If you exit the EVENTS configuration mode with the exit command, you return to the
Global configuration mode.
● If you exit the EVENTS configuration mode with the end command, you return to the
Privileged EXEC mode.
Network protocols
7.6 SMTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
352 Configuration Manual, 07/2017, C79000-G8976-C361-06

Siemens SCALANCE XR-300WG Specifications

General

Brand	Siemens
Model	SCALANCE XR-300WG
Category	Switch
Language	English