You can display the status of this function and other information with the show events
config command.
12.1.8.13 no syslogserver
Description
With this command, you delete a Syslog server.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli (config-events) #
Syntax
Call up the command with the following parameters:
syslogserver {ipv4 <ucast_addr>}
The parameters have the following meaning:
Parameter Description Range of values / note
ipv4 Keyword for an IP address -
ucast_addr Syslog server IPv4 Address Enter a valid IPv4 address.
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The Syslog server is deleted.
Further notes
You add a Syslog server syslogserver.
Diagnostics
12.1 Event and fault handling
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
566 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General