The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the addressed instance 1 ... 64
cost Keyword for the costs of the port for cal‐
culating the lowest-cost path.
-
port-priority Keyword for the priority of the interface -
disable Enables the interface for multiple span‐
ning tree.
-
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting is reset to the default value.
Further notes
You configure the setting with the spanning-tree mst command (properties).
You display these settings and other information with the commands that start with show
spanning tree ....
6.3.5.14 spanning-tree mst hello-time
Description
With this command, you configure the Hello time after which the bridge sends its configuration
frames (BPDUs).
A change to this value applies to all MST instances active on this interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst hello-time <seconds(1-2)>
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 253
To Next Page
Loading...
Need help?
General