set-interface {vlan <vlan-id (1-4094)> | <interface-type> <interface-
id> }
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection. -
vlan-id Number of the
addressed VLAN
1 ... 4094
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The interface is assigned. Before the IPv4 address band can be used, it still needs to be
activated.
Further notes
You display the setting with the show ip dhcp-server pools command.
You enable the IPv4 address band with the pool-enable command.
7.3.3.13 static-lease
Description
With this command you specify that devices with a certain MAC address or client ID are
assigned to the preset IPv4 address.
Requirement
● The assignment has not yet been created.
● You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
static-lease {mac <mac-address> | client-id <string>} <ip-address>
Network protocols
7.3 DHCP server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 305
To Next Page
Loading...
Need help?
General