Syntax
Call up the command with the following parameters:
priority <prio (0-7)>
The parameter has the following meaning:
Parameter Description Range of values / note
prio Value of the priority 0 ... 7
Default: 0
Result
The VLAN has been assigned a priority.
Further notes
You reset the priority to the default value with the no priority command.
You enable the priority with the priority-enable command.
You disable the priority with the no priority-enable command.
You display the current priority with the show vlan command.
You configure the assignment of the priority to a queue with the cos-map command.
6.1.4.6 no priority
Description
With this command, you reset the priority of the VLAN back to the default value.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no priority
Result
The priority of the VLAN is reset to the default value.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
198 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General