Requirement
● You are logged into the device with a local user account
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
change password <passwd>
The parameter has the following meaning:
Parameter Description Range of values / note
passwd Value for the password Enter the password.
The entry depends on the password policy.
The show password-policy com‐
mand shows which password policy is cur‐
rently being used.
Result
The password is changed.
Note
Changing the password in Trial mode
Even if you change the password in Trial mode, this change is saved immediately.
Further notes
You create a user with the user-account command.
You delete a user with the no user-account command.
You show the created users with the show user-accounts command.
You configure the password policy with the password-policy command.
11.1.3 whoami
Description
This command shows the user name of the logged in user.
Security and authentication
11.1 User management
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
500 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General