5.3.2.1 sntp
Description
With this command, you change to the SNTP configuration mode.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
sntp
Result
You are now in the SNTP configuration mode.
The command prompt is as follows:
cli(config-sntp)#
Further notes
You exit the SNTP configuration modewith the end or exit command.
5.3.3 Commands in the SNTP configuration mode
This section describes commands that you can call up in the SNTP configuration mode.
In the Global configuration mode, enter the sntp command to change to this mode.
● If you exit the SNTP configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the SNTP configuration mode with the end command, you return to the Privileged
EXEC mode.
5.3.3.1 sntp client addressing-mode
Description
With this command, you configure the addressing mode of the SNTP client as unicast or
broadcast.
System time
5.3 SNTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
156 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General