Syntax
Call up the command with the following parameters:
duplex {full|half}
The parameters have the following meaning:
Parameter Description Range of values / note
full The Interface will be operated in full du‐
plex mode.
Default: full
half The Interface will be operated in half du‐
plex mode
-
Result
The duplex mode of the interface is configured.
Further notes
You can reset the duplex mode of the Interface to the default value with the no duplex
command.
You disable autonegotiation with the no negotiation command.
3.1.10.6 no duplex
Description
With this command, you reset the duplex mode of an interface to the default value.
The default value is full.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no duplex
Result
The duplex mode of the Interface is reset to the default value.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 79
To Next Page
Loading...
Need help?
General