Result
The entry is deleted from the RMON event table.
12.4.3 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
12.4.3.1 rmon collection stats
Description
With this command, you start the recording of statistical data of an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
rmon collection stats <index (1-52)>[owner<ownername(127)>]
The parameters have the following meaning:
Parameter Description Range of values / note
index Number of the recording 1 ... 52
owner User to which the event is assigned -
ownername User name of the user max. 127 characters
Result
The recording of statistical data is started.
Diagnostics
12.4 RMON
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 583
To Next Page
Loading...
Need help?
General