You display the configured SNMP groups with the show snmp group command.
You display the access configurations for SNMP groups with the show snmp group
access command.
You display the configured SNMP tree views with the show snmp viewtree command.
7.5.2.6 snmp community index
Description
With this command, you configure the details of an SNMP community.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp community index <CommunityIndex> name <CommunityName>
security <SecurityName> [context <Name>][{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter Description Range of values / note
CommunityIndex Index of the community max. 32 characters
name Keyword for the name of the community -
CommunityName Name of the community max. 32 characters
security Keyword for the security name -
SecurityName Security name max. 32 characters
context Keyword for the context name -
Name Context name max. 32 characters
Storage type Specifies whether the settings remain
following a restart.
● :
The settings are lost after a
restart
● :
The settings are retained after
a restart
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
334 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General