cli(config)#
Syntax
Call up the command with the following parameters:
ring-redundancy mode {ard | mrpauto | mrpclient | hrpclient |
hrpmanager}
The parameters have the following meaning:
Parameter Description Range of values / note
ard Enables the automatic redundancy mode
(Automatic Redundancy Detection)
● Default setting with PROFINET
variants: enabled
● Default setting with EtherNet/IP
variants: disabled
● Default setting with Industrial
Ethernet variants: disabled
mrpauto Enables the automatic MRP manager -
mrpclient Enables ring redundancy with the MRP pro‐
tocol as client
-
hrpclient Enables ring redundancy with the HRP pro‐
tocol as client
-
hrpmanager Enables ring redundancy with the HRP pro‐
tocol in ring redundancy manager mode
-
Result
The ring redundancy function is enabled and the redundancy mode is selected.
Further notes
You disable the ring redundancy function with the no ring-redundancy command.
8.4.5.5 no ring-redundancy
Description
With this command, you disable the ring redundancy function on a device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 397
To Next Page
Loading...
Need help?
General