You can display the status of this function and other information with the following commands:
● show spanning-tree detail
● show spanning-tree active detail
● show spanning-tree interface
6.3.5.12 spanning-tree mst
Description
With this command, you configure the various properties of the Multiple Spanning Tree
function:
● With the cost option, you configure the port costs used to calculate the lowest-cost path.
● With the port-priority option, you configure the priority of the interface for negotiating
a Multiple Spanning Tree configuration.
● With the disable option, you disable the interface for the Multiple Spanning Tree function.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree mst<instance-id(1-64)>
{cost(0-200000000)|port-priority (0-240)|disable}
The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the addressed instance 1 ... 64
cost Costs of the port for calculating the low‐
est cost path.
0 ... 200000000
Default:
● 200000 for physical interfaces
● 199999 for port channels
port-priority Priority of the interface 0 ... 240 in steps of 16
Default: 128
disable Disables the interface for multiple span‐
ning tree
Default: MST is disabled, RST is
enabled
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 251
To Next Page
Loading...
Need help?
General