12.1.8.3 no client config
Description
With this command, you disable one of the clients that processes or forwards the messages
of the device.
Requirement
You are in the EVENTS Configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
no client config {syslog|trap|email|all}
The parameters have the following meaning:
Parameter Description
syslog Disables the client that sends the messages to the Syslog server
trap Disables the client that sends the SNMP traps
email Disables the client that sends the e-mails
all Disables all clients at once
Result
The client selected for the transfer is disabled.
Further notes
You display the status of the events and the clients with the show events config command.
You enable the function with the client config command.
12.1.8.4 event config
Note
The IE switch does not support all parameters, refer to the section "Features not supported
(Page 30)".
Diagnostics
12.1 Event and fault handling
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 555
To Next Page
Loading...
Need help?
General