The parameters have the following meaning:
Parameter Description Range of values / note
GroupName Name of the group max. 32 characters
user Keyword for the user name -
UserName Name of the user max. 32 characters
security-model Specifies which security settings will be
used.
● v1
● v2c
● v3
Storage type Specifies whether the settings remain
following a restart.
● volatile :
The settings are lost after a
restart
● nonvolatile :
The settings are retained after
a restart.
If optional parameters are not specified when configuring a group, the default values apply.
Result
The details of the group are configured.
Further notes
You delete the details of an SNMP group with the no snmp group command.
You display the created SNMP groups with the show snmp group command.
You display the created SNMP user with the show snmp user command.
7.5.2.11 no snmp group
Description
With this command, you delete the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp group <GroupName> user <UserName> security-model {v1|v2c|v3}
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
338 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General