The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-range Number of the addressed VLAN 1 ... 4094
Enter the range limits with a hy‐
phen without spaces.
address Keyword for a MAC address -
aa:aa:aa:aa:aa:aa MAC address -
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The static multicast MAC addresses are displayed.
8.6.1.4 show multicast-block config
Description
This command shows the multicast blocking settings for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show multicast-block config [port <interface-type> <interface-id)>]
The parameters have the following meaning:
Parameter Description Range of values / note
port Keyword for a port description -
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
Layer 2 management protocols
8.6 Multicast
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 423
To Next Page
Loading...
Need help?
General