2.5 Structure of the Command Line Interface
Grouping of the commands in the various modes
The commands of the Command Line Interface are grouped according to various modes. Apart
from a few exceptions (help, exit), commands can only be called up in the mode to which
they are assigned. This grouping allows different levels of access rights for each individual
group of commands. The following graphic is an overview of the available modes.
AUTOLEARN
LOADSAVE
Redundancy
User EXEC Mode Privileged EXEC Mode
Global Configuration Mode
Interface Configuration
NTP
SNTP
VLAN
QOS
Events
User EXEC mode
This mode is active after you log in with the role "user" in a console window. In this mode,
you can use show commands to display the current values of configuration parameters. It is
not possible to modify parameters in this mode.
General information
2.5 Structure of the Command Line Interface
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
32 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General