Set Up and Maintenance
9836 3521 01 209
4.17.7.5 Change Net Data
This form is used for changing the network settings for one or more TCs.
Enter the new values in the field displayed
The Main Net Address determines the first three numbers in the IP address for the TC. The TC number
set on on the TC display gives the last number of the address.
If you set a network mask with a nonzero value as the last number you must manually ensure that the
Default Gateway belongs to same network as all the TCs.
Click OK to send the new values to the TCs. The result of this request is displayed in the Configure Target
System form (see chapter: Configure Target System).
Keep in mind that the new values will not be displayed in the list until the TCs are restarted. The reason
for this is that the list always shows the currently used data and the TC will not use the new values until it
is restarted.
Note! This command requires that the Console Computer is on the same network as the target system(s)
to modify, or there must exist a route between them.
To Next Page
Loading...
Need help?
General
