Set Up and Maintenance
214 9836 3521 01
If any of the above conflicts are detected for the selected system when going on-line then a warning is
written on the caption bar of ToolsTalk PowerMACS and this form is displayed automatically. It is not
possible to close the form as long as there are errors in the system.
See also chapter: Tightening Controller for important information on System and Spindle TCs and The TC
HMI Menu System for how versions errors are displayed directly on the TCs. Chapter: Configure Target
System describes for how to download new TC System Software (Prepare TC for download of software)
and how to configure a TC as a System or a Spindle TC (The TC HMI Menu System).
4.17.11 TC Crash Log
The TC Crash Log form is invoked using menu item Maintenance – TC Crash Log…, is a tool that is
used to collect debug information from one or more TCs that crashed due to an internal software error.
Normally you should not run in to situations where this tool is needed but if you do the data it retrieves can
be of great help to Atlas Copco when analyzing the fault.
Use the Fetch log from TC combo box to select which TC to upload data from. Choosing the All
alternative will make all TCs be polled for data.
To Next Page
Loading...
Need help?
General
