Atlas Copco PowerMACS 4000 User Manual

Basic Functions
82 9836 3521 01
3.6.7 View Event Log
In the PowerMACS system events could happen that the operator should be informed of. These can be of
following types:
Event type
Num. Id
Example
General
0
Events that do not belong to any of the specific categories below.
Access
1
Operator log-in and log-out, failed log-in attempts
Power up
2
Restart of system
Emergency stop
3
Emergency or Machine stop of station
Checks
4
Tightening application errors, ”Torque high”, ”Angle low” etc.
System error
5
Abnormal situation, hardware breakdown etc.
Modifications
6
Changed parameter. Event contains additional information, like
parameter, station, spindle, program etc.
Hardware error
7
Hardware related errors, servo failure etc.
Software error
8
Internal communication errors, etc.
Ext. com. error
9
No response, to many retransmissions, etc., when communicating with
external equipment.
SPC
10
SPC events, "7 up", "7 down", etc.
Setup
11
Erroneous configuration detected during run mode, e.g. missing
parameters, etc.
All events are also classified by their Severity. Severity is one of the following:
Severity
Num. Id
Example
Info
0
Events that only informs the user of some activity, for example "Power
on".
Warning
1
Events that may indicate unexpected behavior, for example "Machine
stop".
Error
2
Severe errors in the system or events that indicate that cycle failed, the
error might be repairable.
Num. Id. above is the numerical identity of the respective Event Type. This value is used when events are
reported to binary devices. See Layout of Events for a complete description of the binary format of events.
All events are stored in an Event Log, which can be viewed using ToolsTalk PowerMACS.

Atlas Copco PowerMACS 4000 Specifications

General

Brand	Atlas Copco
Model	PowerMACS 4000
Category	Power Tool
Language	English