3 Copy
114
Copy
3
Job Assembly
On the [Job Assembly] screen, you can configure the Build Job features. The following
shows the reference section for features that can be configured on [Job Assembly].
Build Job (Making Copies of Documents with Different Settings in a Single Operation).......114
Sample Set (Confirming the copy appearance meeting your expectations) .............................118
Large Volume Document (Loading documents in Batches).....................................................119
Form Overlay (Making copies to overlay documents) .............................................................120
Delete Outside/Delete Inside (Extracting/Deleting the selected area(s) from the original) .....121
1 On the [All Services] screen, select
[Copy].
Select the [Job Assembly] tab and
then select a feature on the [Job
Assembly] screen that appears.
Build Job (Making Copies of Documents with Different Settings in a
Single Operation)
This feature allows you to change and save settings individually for each document
page or bunch and then to finally make copies of documents with different settings as
one job.
Important • When you use tab papers for [Covers] or [Separators], select [Face down] in [Output
Orientation] of [Output Format].
1 Select [Build Job].
2 Select [On].
3 Select items displayed as
necessary.
Note • You can display the previous
screen by selecting[ ] and
display the next screen by
selecting [ ].
îš„Off
Build Job is not applied.
îš„On
Build Job is applied. Set any item first as necessary.
Important • Once selected, the settings except [Separators] cannot be changed during copying.
For the copying features that can be programmed, refer to "Copying Features for the Entire Job" (P.115).
To Next Page
Loading...
Need help?
General
