Replacing Consumables
467
Maintenance
14
Emptying Punch Scrap Container
The message will be displayed, when it is time to empty the punch scrap container.
Discard the scraps according to the message.
When pulling the punch scrap container out to dispose the punch scraps, ensure that
all scraps are discarded. If there are scraps remaining, the container may be full before
the next message is displayed, and this may cause machine breakdown.
Important • Remove the container while the power is on. If you switch off the power when emptying the
scrap container, the machine will not be able to detect that the scraps have been disposed.
1 Make sure that the machine has
stopped, and then open the right
cover on the light finisher.
2 Pull out the punch scrap container
R4.
3 Discard all the scraps.
4 Insert the empty punch scrap
container as far as possible.
5 Close the Finisher's right cover.
Note • A message will be displayed and the machine will not operate if the Staple Finisher's right
cover is even slightly open.
To Next Page
Loading...
Need help?
General
