Print Mode Settings
347
Setups
10
Other Settings
Make settings relating to the paper used in the printer.
1 Select [Other Settings].
2 Select the item to be set or
changed, and select [Change
Settings].
Note • Select [ ] to display the
previous screen and select
[ ] to display the next screen.
3 Select the setting value.
4 Select [Save].
Print Area
Set whether to expand the print area.
For information about the print area, refer to "Printable Area" (P.558).
Substitute Tray
When there is no tray containing the paper size selected by the automatic tray
selection, select whether or not to print replaced with paper loaded in another paper
tray. In the event of using substitute tray, set the size.
îš„Display Message
Do not use substitute tray, but display a paper loading message.
îš„Use Larger Size
Replace with the next larger paper size than that selected, and print at the same size.
îš„Use Nearest Size
Replace with the closest paper size to that selected, and print. If necessary, the printing
is automatically reduced in size.
Note • If there is a client specification, the client specification takes precedence.
îš„Select Tray 5 (Bypass)
Prints on the paper loaded in tray 5 (Bypass).
Paper Type Mismatch
Set the action to be taken when the paper type loaded in the paper tray does not match
that specified.
îš„Print
Prints using the paper loaded in the paper tray.
îš„Display Confirmation Screen
Shows a confirmation screen, and prompt for action.
îš„Display Paper Supply Screen
Displays a screen which enables to change paper types of a selected paper tray.
To Next Page
Loading...
Need help?
General
