3 Copy
80
Copy
3
Mixed Size Originals
(Scanning Different Size Documents Simultaneously)
You can simultaneously scan different size documents onto paper that matches the
respective sizes of the documents. You can also specify the size of the paper to make
copies so that copies are made on the same size of paper.
Important • Be sure to load A5 documents vertically.
• When loading a B5 size document with A3 or A4 size documents in a vertical direction, place
the B5 document also in a vertical direction. The combination of document sizes other than
these may cause paper jams.
• The recommended combinations of document sizes are A4 portrait and A3 landscape, or B5
portrait and B4 landscape. When you the combination of document sizes other than these,
documents may not be fed or scanned properly.
Note • [Original Orientation] is set in reference to the direction set for the first page of the document.
Load the rest of the document from the second page onwards in the same direction as that
of the first page of the document.
1 Select [Mixed Size Originals].
2 Select [On].
3 Select [Original Orientation].
îš„Off
Select this item when all documents are of the same size.
îš„On
When documents of different sizes are copied, the machine automatically detects the
size of each document.
Edge Erase (Erasing Edges and Margin Shadows of the Document)
When you make copies with the document cover open or make copies from a book,
black shadows sometimes appear along the edges and center margin of the paper. If
this happens, you can make copies with the shadows erased.
Note • When copying 2 sided originals, the same border erase amount is set for the top and bottom
sides.
• If you set [Reduce/Enlarge], the edge erase dimensions will be reduced / enlarged in
proportion to the ratio you configured.
For information about the areas that can actually be printed, refer to "Printable Area" (P.558).
To Next Page
Loading...
Need help?
General
