2 Product Overview
40
Product Overview
2
Power Saver Mode
The machine is installed with a Power Saver feature that will automatically cut off the
electricity to the machine if no copy or print data is received for a certain duration.
The Power Saver feature has two modes, a [Low Power mode] and [Sleep mode].
The machine enters the [Low Power mode] after the preset time has elapsed if the
machine is left unused for a fixed period of time.
The machine then enters the [Sleep mode] if a further preset time elapses.
îš„Low Power Mode
In this mode, the power to the control panel and fuser unit is lowered to save power.
The disp
lay g
oes out,
and t
he <P
ower Save
r> bu
tton on th
e con
trol pa
nel l
ights. To
use
the mach
ine, pre
ss the <Po
wer Saver> bu
tton. Th
e <Power Save
r> butto
n goes ou
t to
indicate that the Power Saver feature is canceled.
îš„Sleep Mode
In this mode, the power is lowered more than in the Low Power mode.
The disp
lay g
oes out,
and t
he <P
ower Save
r> bu
tton on th
e con
trol pa
nel l
ights. To
use
the mach
ine, pre
ss the <Po
wer Saver> bu
tton. Th
e <Power Save
r> butto
n goes ou
t to
indicate that the Power Saver feature is canceled.
Changing the Power Saver Mode Change Interval
The procedure for setting the Power Saver feature is as follows.
To activate the Power Saver feature, set the Sleep Mode button to Enabled, and set
both the times up to migration to the Low Power Mode and migration to the Sleep
Mode.
Note • The time to migration to Low Power Mode and Sleep Mode can each be specified in 1
minute increments, from 1 to 240 minutes.
1 Press the <Log In/Out> button.
2 Enter the system administrator ID
with the numeric keypad or a
keyboard displayed by pressing
[Keyboard], and select [Confirm].
Note • The default UserID value is
"11111". When using the
authentication manager
feature, a password is
required. The default
password value is "x-admin".
<Log In/Out>
button
To Next Page
Loading...
Need help?
General
