15 Problem Solving
476
Problem Solving
15
Machine Trouble
If you think some trouble is occurring on the machine, check the machine status again.
Symptoms Check Remedy
Power is not
switched On.
Is the power switch on the
machine off?
Turn the power switch on.
Refer to "Power On / Off" (P.38).
Is the power cord plugged
into the power outlet?
Turn the power switch off and then firmly
plug in the power cord. Then turn the
power switch on.
Refer to "Power On / Off" (P.38).
Is the power cord
disconnected from the
machine?
Is power of the correct
voltage being supplied?
Make sure that the power supply is 200 -
240 V (volts), 15 A (amperes).
Make sure that power of capacity
compatible with the specified maximum
power consumption of the machine (2.8 -
3.1 KVA) is being supplied.
Display is dark.
Is the <Power Saver>
button on?
The machine is in the Power Saver mode.
Press the <Power Saver> button on the
control panel to cancel the Power Saver
mode.
Refer to "Power Saver Mode" (P.40).
Is the brightness dial set too
low?
Use the brightness dial to adjust display
brightness.
Refer to "Control Panel" (P.44).
Unable to print,
or
unable to copy.
Is a message displayed on
the control panel's display?
Follow the instructions displayed to solve
the problem.
Is the printer mode [Offline]? Press the <Machine Status> button and
confirm the [Printer Mode] in the [Machine
Status] screen. If [Printer Mode] is [Offline],
select [Online] in the [Printer Mode] screen.
Is the power cord
disconnected from the
machine or the rear of the
rack?
Turn the power switch off and then firmly
plug in the power cord. Then turn the
power switch on.
Refer to "Power On / Off" (P.38).
<Online>
indicator does
not light even
though you
instructed it to
print.
Is the interface cable
disconnected?
Turn the power switch off, unplug the
power cord from the power outlet, and
check the interface cable connection.
For information about Network Settings, refer
to Network Administrator Guide.
Is the personal computer's
environment correctly set?
Check the print driver and other
environment settings on the personal
computer.
Is the required interface
set?
Check the status of the interface port in
use.
For information about Network Settings, refer
to Network Administrator Guide.
To Next Page
Loading...
Need help?
General
