Scan Options
79
Copy
3
Original Size (Specifying the Scan Size for the Document)
You can set the scan size for the document.
Specify the size of the document when scanning non-standard size documents or when
making copies at a size different from that of the currently loaded document.
When a document size is specified, it is scanned at the specified size regardless of the
size of the loaded document. This feature allows you to copy the document with adding
or deleting the margin.
1 Select [Original Size].
2 Select the size of the document.
If you select a non-standard size,
specify values for the X and Y
directions.
îš„Auto Size Detect
Scan sizes are detected automatically.
Note • If the document size cannot be detected, a screen to input the document size appears.
îš„Standard size
Select from eleven preset sizes.
You can change the indicated document sizes. For information about the setting procedure, refer to
"Original Size Defaults" (P.336).
îš„Free
Enter the desired scan size when scanning non-standard size documents or when
making copies at a size different from that of the currently loaded document. The size
can be specified in 1 mm increments within the range from 15 to 432 mm for the width
(X) on the document glass and within the range from 15 to 297 mm for the height (Y)
on the document glass. The scale on the outside of the document glass is a useful
reference for specifying the document size.
To Next Page
Loading...
Need help?
General
