Stapler Faults
541
Problem Solving
15
Staple Jams in the staple cartridge
The following describes remedy for staple jams in the staple cartridge.
For information about the procedure when the staple case is taken off from the cartridge before using
staples completely, refer to "Staple Cartridge Taken Off from Unit" (P.606).
1 Make sure that the machine has
stopped, and then open the front
cover on the light finisher.
2 Hold the R1 at the position shown
in the diagram.
3 Pull out the unit.
Note • After removing the staple
cartridge, check the inside of
the finisher for any remaining
staples.
4 Open the staple cartridge cover as
shown in the diagram and remove
all the jammed staple.
5 Push the removed unit back to the
original position.
6 Close the Finisher right cover.
Be careful in removing jammed
staples.
To Next Page
Loading...
Need help?
General
