3 Copy
92
Copy
3
îš„None
No Finishing is carried out.
îš„Folding
Outputting copies folded in half.
îš„Folding + Stapling
The copies are folded in half and stapled at the center. Then, the number of copies that
can be stapled is 2 to 15.
[Booklet Creation -Subsets] screen
A booklet is divided by every number of sheets specified when there was much number
of sheets of a document. It can copy so that what made each 2-sided copy could be
piled up become a booklet. You can set the number of sheets in the range from 1 to 50
sheets in 1 sheet increments.
Note • When specifying [Fold], set the dividing number of sheets in the range from 1 to 15.
When there is much number of sheets, it can divide that booklet does not become thick.
Copies are assigned and discharged in order by specified number of sheets. You can
set the number of sheets (number of division) in the range from 1 to 50 sheets.
For example, if paper number of sheets (the number of division) is set as "5" in order
to use one sheet (side 1/side 2) of paper with four documents when creating a booklet,
a document will be assigned per 20 sheets.
1 Select [On] or [Off].
2 If you select [On], use [ ] and [ ]
or the numeric keypad to specify
number of sheets.
Covers (Attaching a Cover to Copies)
You can make copies with a cover attached.
The front and back cover can be output before the first page of the document on a
different type of paper (e.g. colored paper or heavyweight paper).
Important • When you select this feature, if the number of the document pages exceeds the maximum
that the machine can scan, the document already scanned (scanned document) cannot be
printed, copied or saved. In this case, cancel the job following the message displayed. The
maximum number of the document pages that can be scanned is 2,000 pages per job. For
multiple jobs, the maximum is about 20,000 pages altogether if the document size is A4L.
This figure could be used only as a guide, since the maximum number of the document
pages depend of the types, sizes and direction of the document.
• When you use tab papers, select [Face down] in [Output Orientation] of [Output Format].
To Next Page
Loading...
Need help?
General
