Fuji Xerox Document Centre 1100 User Manual

15 Problem Solving
474
Problem Solving
15
Troubleshooting
This section describes troubles that may occur with the machine and their solutions.
See the following for troubleshooting procedures to solve the problems.
Power is not switched On.
Cause Is the power switch on the machine off?
No Yes Action Turn the power switch on.
Refer to "Power On / Off" (P.38).
No
Cause Is the power cord plugged into the power outlet?
Action Turn the power switch off and then firmly plug in the power
cord. Then turn the power switch on.
Refer to "Power On / Off" (P.38).
No
Cause Is the power cord disconnected from the machine?
Action Turn the power switch off and then firmly plug in the power
cord. Then turn the power switch on.
Refer to "Power On / Off" (P.38).
No
Cause Is power of the correct voltage being supplied?
Action Make sure that the power supply is 200 -240 V (volts), 15 A
(amperes).
Make sure that power of capacity compatible with the
specified maximum power consumption of the machine (2.8
- 3.1 KVA) is being supplied.
Display is dark.
Cause Is the <Power Saver> button on?
No Yes Action The machine is in the Power Saver mode. Press the
<Power Saver> button on the control panel to cancel the
Power Saver mode.
Refer to "Power Saver Mode" (P.40).
No
Cause Is the Brightness Dial set too low?
Action Use the Brightness Dial to adjust display brightness.
Refer to "Control Panel" (P.44).
A message is displayed. Cause Has a paper jam or document jam occurred?
No Yes Action For information on paper jams, refer to "Paper Jams" (P.513).
For information on document jams, refer to "Document Jams"
(P.537).
No
Cause An error code displayed?
Action Refer to "Error Code" (P.498).
The machine is not working
properly.
Action Refer to "Machine Trouble" (P.476).
No Yes

Fuji Xerox Document Centre 1100 Specifications

General

Brand	Fuji Xerox
Model	Document Centre 1100
Category	All in One Printer
Language	English