Cleaning the Machine
469
Maintenance
14
1 Wipe the document cover with a
soft cloth moistened with water to
remove any dirt and then wipe it
with a soft, dry cloth.
Important • Never use cleaning
substances other than water
or neutral detergent.
Note • If it is difficult to remove dirt,
try gently wiping with a soft
cloth moistened with a small
amount of neutral detergent.
2 Wipe the document glass with a
soft cloth moistened with water to remove any dirt and then wipe it with a soft, dry
cloth.
Important • Never use cleaning substances other than water or neutral detergent.
Note • If it is difficult to remove dirt, try gently wiping with a soft cloth moistened with a small amount
of neutral detergent.
Cleaning the Document Cover and Document Glass
If the document cover and document glass are dirty, dirt may appear on copies.
To ensure that clean copies are made, clean the machine about once a month or clean
it when a message is shown on the display.
Important • Do not use benzene, paint thinner, or other organic solvents. Doing so might damage paint
or coating on plastic parts.
• Cleaning the machine with an excessive amount of water may cause the machine to
malfunction or damage documents during copying.
1
Wipe the document cover with a
soft cloth moistened with water to
remove any dirt on the document
cover, glass and guide, and then
wipe it with a soft, dry cloth.
Important • Never use cleaning
substances other than water
or neutral detergent.
Note • If it is difficult to remove dirt,
try gently wiping with a soft
cloth moistened with a small
amount of neutral detergent.
2 Holds the lever to open the part of
the figure on the right. Wipe the
optical glass with a soft cloth
moistened with water to remove
any dirt on the optical glass, and
then wipe it with a soft, dry cloth.
Important • Do not push the optical glass
strongly since it is easy to
damage the film around the
optical glass surface.
• Never use cleaning
substances other than water
or neutral detergent.

To Next Page
Loading...
Need help?
General
