To Next Page

To Previous Page

Common Settings

303

Setups

Non-Copy Job Complete Tone

Select the sound to be made when a job other than copying completes.

You can select the volume from [Loud], [Normal], and [Soft]. To disable the sound,

select [Off].

Fault Tone

Select the sound to be made when there is an error termination.

You can select the volume from [Loud], [Normal], and [Soft]. To disable the sound,

select [Off].

Auto Clear Alert Tone

Select the sound to be made when the automatic clear feature is enabled and it is 5

seconds before automatically returning to the initial screen.

You can select the volume from [Loud], [Normal], and [Soft]. To disable the sound,

select [Off].

Alert Tone

Select the sound to be made when a fault such as a paper jam occurs, and the fault is

left unattended to.

You can select the volume from [Loud], [Normal], and [Soft]. To disable the sound,

select [Off].

Out of Paper Warning Tone

Select the sound to be made when there is no paper in the paper tray and the job is left

unattended to.

You can select the volume from [Loud], [Normal], and [Soft]. To disable the sound,

select [Off].

Low Toner Alert Tone

Select the sound to be made when the toner cartridge is due to be replaced.

You can select the volume from [Loud], [Normal], and [Low]. To disable the sound,

select [Off].

Stored Programming Tone

Select the sound to be made while recording in job memory.

You can select the volume from [Loud], [Normal], and [Soft].

Note • It is not possible to disable this sound.

Fuji Xerox Document Centre 1100 User Manual

Other manuals for Fuji Xerox Document Centre 1100